Kolbus Da — 36 Manual =link=

Securing a copy of the official manual may be challenging, but it is not impossible. Here are actionable strategies:

Adjust the separation air blasts to ensure only a single sheet is lifted at a time. Too much air causes paper flutter; too little causes double-sheet feeds.

Automatic gluing of cover material, placement of greyboard/spine strips, and turning-in of edges. Material Types: Kolbus Da 36 Manual

Deepen the stroke of the corner irons; ensure cloth corners are cut to the proper dimensions. Imbalance of moisture/temperature between glue and board.

The DA 36 was revolutionary for its time because it introduced synchronized case feeding and continuous book block infeed. The manual from this era is not merely a parts list; it is a philosophy of mechanical synchronization, written in dense German technical prose (later translated into English, Spanish, and French for export markets). Securing a copy of the official manual may

Set the feeding pile guides so the cover material sits squarely. Adjust the back and side guides to allow roughly 1 mm of clearance.

Operators must adjust settings for specific book dimensions and material types (cloth, paper, or plastic) to ensure optimal bonding. Material Feeding: The DA 36 was revolutionary for its time

The Kolbus DA 36 was built for medium to high-volume production of hard book covers, rigid box components, and files. Below are the standard mechanical parameters for the machine: 405 x 560 mm Minimum Opened Case Size: 110 x 155 mm Spine Insert Width: 8 mm to 80 mm Maximum Speed: Up to 36 cycles per minute

The glue tank, rollers, and hoses operate at high temperatures. Always wear thermal-resistant gloves during glue maintenance.

Before operating or adjusting the Kolbus DA 36, it is critical to understand its mechanical limits and capabilities. Running materials outside of these parameters can cause jam-ups, poor gluing quality, or mechanical damage. Size Range Capabilities 405 mm x 560 mm (15.94" x 22.05") Minimum Case Size (Open): 110 mm x 155 mm (4.33" x 6.10") Maximum Joint Width: 14 mm (0.55") Turn-in Width: 8 mm to 15 mm (0.31" to 0.59") Material Specifications Board Thickness: 1.0 mm to 4.0 mm (0.04" to 0.16") Spine (Center Strip) Thickness: Up to 3.0 mm (0.12")

A later variant, the Kolbus DAS 36, appeared on the used market in 1995 with slightly different maximum cover dimensions of (420\times 660) mm.