How To Reset Sharp Ar-6020 Jun 2026

Before attempting to reset your Sharp AR-6020, consider these precautions:

To completely wipe all custom settings and return the machine to its original state: Navigate to on the display.

A full factory reset will clear custom network settings, IP addresses, and default print settings. Take photos of your configuration page first ManualsLib.

To avoid encountering issues with the Sharp AR-6020 in the future, John made sure to: how to reset sharp ar-6020

Do not turn off the machine while it reformats its internal NVRAM. Troubleshooting Common Reset Failures

For detailed troubleshooting, consulting the official Sharp AR-6020 Operation Guide is recommended.

This returns the machine to default settings (paper size, energy save, etc.). It does NOT clear the maintenance counter. Before attempting to reset your Sharp AR-6020, consider

: Required when the maintenance indicator (spanner icon) stays lit after servicing. Use Simulation as described above. Developer Initialization

Use the arrow keys to scroll to and press OK . Enter the default administrator password ( admin ).

If your Sharp AR-6020 is locked out due to a critical engine error (like a fuser overheating code), the machine will refuse to print even after the physical problem is fixed. You must manually clear the system log using . Enter Simulation Mode (Using the sequence in Section 2). Type 14 using the numeric keypad. Press the Start (Black & White copy) button. To avoid encountering issues with the Sharp AR-6020

Select and press ENTER again to confirm. The machine will inform you that all values are returning to default. 4. Admin Password Reset

Wait exactly to allow the internal capacitors to drain completely. Plug the power cable back into the wall. Turn the machine ON and check if the error persists. 2. Entering Sharp AR-6020 Service Simulation Mode

To reset a Sharp AR-6020 , you must first determine if you need to clear a specific error code or return all settings to factory defaults.

Enter the factory default administrator password. For the Sharp AR-6020, the default password is typically or 000000 . Navigate to Default Settings or Initialize .

Press the key to change the displayed page value to 000000 . Press Start to save. Press Clear All (CA) to exit. Clearing the Developer Counter (Sim 24-06): Enter Simulation Mode . Type 24 and press Start . Type 6 (sub-code for developer counter) and press Start . Press the Clear key to zero out the count. Press Start to lock it in, then press Clear All (CA). 5. Re-Calibrating the Developer (Simulation 25-01)