Smartpack2 Touch User Manual • Plus

Select to save your custom system settings as a file. Updating Firmware via USB

Navigate to Commands > Battery Test > Start Test .

The touch interface does not override physical safety. smartpack2 touch user manual

A non-volatile rolling archive detailing past events, clear times, and operator acknowledgments. 3. Configuration (PIN Required)

If you have any questions or need further assistance with your Smartpack2 Touch, here are some resources: Select to save your custom system settings as a file

Select the file from the onscreen list and tap . Do not remove power or the USB drive during this process. 7. Technical Specifications Quick Reference Specification Details Display Type 3.2-inch TFT color resistive touchscreen Input Voltage Range 18 VDC to 66 VDC Power Consumption Maximum 5 Watts Operating Temperature -20°C to +60°C (-4°F to 140°F) Ethernet Protocols IPv4/IPv6, Web-GUI (HTTP/HTTPS), SNMP v1/v2c/v3, Modbus TCP

25W (15W + 10W simultaneously).

The Smartpack2 architecture separates the user interface from the control electronics. The Touch controller coordinates with the , which handles the actual power routing, rectifier control, and localized alarm relays. If the screen is damaged, the core system continues to run safely in the background. 2. Initial Setup and Navigation

| Gesture | Function | |---------|----------| | Single tap (center) | Show battery level (LED strip lights 1-5 bars) | | Double tap (center) | Toggle heated pocket ON/OFF (40°C / 104°F) | | Swipe up (long) | Increase brightness of LED strip (3 levels) | | Swipe down (long) | Decrease LED brightness / dim to off | | Swipe left (short) | Output mode: Standard (normal charging speed) | | Swipe right (short) | Output mode: Fast (15W delivery to devices) | | Tap + hold (3 sec) | Emergency alarm (110 dB siren + flashing LEDs) | A non-volatile rolling archive detailing past events, clear

Select the specific hardware relay (e.g., Relay 1 on I/O Monitor).