The Ultimate Guide to OScam Server Configuration OSCam (Open Source Conditional Access Module) is a powerful, highly customizable software used to manage smartcards and distribute television subscription codes across local networks. Configuring an OSCam server requires a solid understanding of its core configuration files.

: Configures the traditional Newcamd protocol. The syntax 15000@0100:00006A binds port 15000 to CAID 0100 and Provider ID 00006A .

: Configures the load balancer to always select the fastest responding reader.

Create a file named oscam.dvbapi in your configuration directory:

I can provide the specific and MHz settings for your exact provider.

[reader] label = card_one caid = 0D95 group = 1 ... [reader] label = card_two caid = 0D95 group = 1 ...

oscam.dvbapi is an optional but important file when OSCam is used to descramble channels on the same device where it runs (e.g., on an Enigma2‑based receiver or with Tvheadend). It defines rules that tell OSCam which ECM (Entitlement Control Message) to use for a given channel. The rules are applied in order, with the first match being used.

: A vital logical setting. Every reader must belong to a group (e.g., Group 1, Group 2). Users can only access readers if they share the same group number.

Configuring an requires setting up four core text files, typically located in /usr/local/etc or /etc/tuxbox/config . Each file handles a specific part of the server's logic, from global network settings to individual user access. 🛠️ Essential Configuration Files oscam.conf (Global Settings)

Installation methods vary, but for most Linux systems:

sudo useradd -r -s /sbin/nologin oscam

To reduce load on your local card, enable Cache Exchange in the reader: