STAY CONNECTED
, requiring users to navigate through menus by trial and error (typically selecting the middle option to proceed). Administrative Rights
Open MKS Laser Tool and connect to your board via the correct COM Port. Navigate to the tab.
Some users have reported that the tool may fail with an error unless it is run as Administrator . If you encounter any issues, right-click the MKSLaserTool executable and select "Run as administrator".
Input your home or workshop (Network Name) and Password . Note: The ESP32 chip only supports 2.4GHz WiFi networks; it will not connect to 5GHz bands. Click Connect or Write Configuration . mks laser tool setup v112exe download link
Follow these steps to install the tool cleanly on your Windows computer.
: Configure host addresses for mobile app and browser monitoring. Safe Download Guide for MKS Laser Tool V1.1.2.exe
Open the Windows and check under Ports (COM & LPT) to identify your assigned COM port (e.g., COM3). How to Use MKS Laser Tool V1.1.2 , requiring users to navigate through menus by
Click then Run Anyway if Windows SmartScreen appears. Select your preferred installation directory. Click Next and complete the installation wizard. Launch the application from your desktop shortcut. Initial Configuration & Firmware Flashing
The primary use of this tool is uploading firmware to the DLC32 board [1]. Flashing DLC32 Firmware Open the MKS Laser Tool [1]. Select the tab [1]. Choose your board type (e.g., MKS DLC32) [1]. Browse and select your target .bin firmware file [1]. Select the correct COM Port assigned to your board. Click Start and wait for the progress bar to reach 100%. Connecting to WiFi
Upload custom UI assets and icons to your MKS TFT display. Some users have reported that the tool may
Before configuring the software, establish a stable hardware connection. Required Drivers
The DLC32 board features built-in WiFi, allowing you to untether your laptop from the laser cutter. Click the tab in the software. Input your home or workshop WiFi SSID (Name) and Password . Click Connect/Save .
Select the correct assigned to your board (check Windows Device Manager if you are unsure).
