Upon inserting the battery, the second hand will move to the 12 o'clock position. The hour and minute hands may spin rapidly as they search for the current time signal.
After setting the date, the clock will exit setting mode automatically.
: Press and hold the SYNC or UP button for 3 seconds to manually trigger a reception test. Troubleshooting Common Issues Sharp atomic clock spc373
The clock is actively searching for the atomic signal. sharp atomic clock spc373 user manual
Press and hold the button on the back of the clock for approximately 3 seconds until the display digits begin flashing.
Open the battery compartment cover on the back of the clock. Insert 2 fresh AA alkaline batteries, matching the polarity diagrams (+ and -) marked inside the compartment.
The atomic signal is strongest at night. It may take up to 24 hours for the clock to successfully capture the signal and set itself to the exact second. Programming Guide: Manual Settings Upon inserting the battery, the second hand will
This indicates the clock is still searching. If it has been over 24 hours, change the location, as radio interference may be preventing a fix. 8. Product Care & Maintenance
Use UP or DOWN to change the hour. Note: Ensure the PM indicator is correct if using 12-hour format. Press SET .
To ensure your clock establishes a strong connection with the atomic signal, follow these initial setup steps precisely. : Press and hold the SYNC or UP
Hold the button until the digits flash, then use the buttons to set your desired time.
Press the MODE button and use the UP button to change the zone indicator to match your location (P, M, C, or E).
Position the clock near a window, facing toward Fort Collins, Colorado.
Need Help with Your Sharp Atomic Clock SPC373? Check Out Our User Manual Guide!
Adjust the current hour (ensure AM/PM is correct if using the 12-hour format). Minute: Adjust the current minutes. Selecting Your Time Zone