Rok Power Washer Instructions New [patched]
Let the soap sit for 3-5 minutes, then switch to a high-pressure nozzle to rinse from top to bottom. 5. Shut Down Procedure
If the engine is cold, move the choke lever over to the position. Set the throttle lever to the FAST (rabbit) position.
Put one foot on the frame to stabilize the unit. Pull the starter cord grip slowly until you feel resistance, then pull it briskly and smoothly.
If you let a petrol pressure washer run for more than two minutes without squeezing the trigger, the water inside the pump will overheat. The thermal relief valve will safely dump hot water onto the ground to protect the pump. To avoid this stress on the machine, turn the engine off if you need to take a break. rok power washer instructions new
Turn the main power dial on the body of the machine to the position. The motor may hum briefly and stop; it will engage fully when you squeeze the spray gun trigger. 4. Understanding and Using the Nozzles
Ensure the water inlet filter mesh screen is cleanly seated inside the machine’s water inlet port. Thread your garden hose adapter onto the inlet port.
Snap the desired nozzle (usually color-coded for different spray patterns) into the end of the lance or wand. 2. Essential Priming Steps Let the soap sit for 3-5 minutes, then
Mix your pressure-washer-approved detergent according to the bottle instructions. Never use household bleach or thick dish soaps, as they will corrode internal pump components.
One of the most common mistakes is starting the motor "dry." Before powering on, turn the water source on and squeeze the spray gun trigger to purge air from the system. 2. Powering the Unit
Watch this step-by-step demonstration on how to correctly prime and operate a consumer pressure washer: How to Use a Pressure Washer Family Handyman YouTube• Jun 9, 2023 How to Use a Pressure Washer Set the throttle lever to the FAST (rabbit) position
Allow the soap to sit on the surface for 3–5 minutes to break down dirt, but do not let it dry on the surface.
Switch back to a high-pressure nozzle (such as the Green 25° nozzle) to rinse the soap away from the top down. 6. Essential Safety Rules
The motor may hum for a second and stop—this is normal. It will automatically engage when you pull the gun trigger. Starting a Petrol Model: Turn the engine switch to the position. Slide the fuel valve lever to the ON position (right).
– not on loose gravel or uneven ground.